Publicité
Les langues disponibles
Les langues disponibles
Reassembly of FX
Complete Cleaning)
1.
Re-install the Goggle Frame and lens into the FX
Note: To facilitate the FX
the table.
2. From inside of the FX
Protector, insert the lower (right) corner of the
Goggle Assembly into the lower corner of the FX
9004 Helmet, Head Protector's plastic goggle
shell (see Fig. 43).
3. Using your thumb, insert the second lower (left)
®
corner of FX
9003/9004 Goggle Assembly into
®
9004 Helmet, Head Protector's plastic
the FX
goggle shell lower corner (see Fig. 44a).
4. Again, using the thumb, insert the top (left and
right)
corners
Assembly into the FX
Protector's plastic goggle shell top cavity. (see
Fig. 44b).
Note: Some physical effort may be necessary to
completely lodge the FX
Assembly in the FX
Protector.
5. Finally, make sure that FX
plastic shell (see Fig. 45, 46 and 47).
Fig. 45 – FX
®
9004 Goggle Assembly
installation verification
© 2022 General Dynamics-OTS Canada
®
9004 Helmet, Head Protector after cleaning as per Procedure 2 (Mask's
®
9003/9004 Frame with the lens installation, place FX
®
9004 Helmet, Head
®
of
FX
9003/9004
®
9004 Helmet, Head
®
9004 Goggle
®
9004 Helmet, Head
®
9003/9004 Goggle Assembly is fitted securely into the FX
Registered trademarks of General Dynamics Ordnance and Tactical Systems-Canada Inc. are denoted by
®
9004 Helmet, Head Protector's plastic shell (see Fig. 43).
®
Goggle
Fig. 44 - FX
®
9004 Helmet, Head Protector's plastic goggle shell lower corner
Fig. 44a – Insertion in the second lower
(left) corner
Fig. 46 - FX
®
9004 Goggle Assembly
installed foams
www.simunition.com
®
9004 Helmet, Head Protector on
Fig. 43 – Returned fabric front piece
Fig. 44b - Insertion in the second top
®
9004 Helmet, Head Protector's
Fig. 47 – FX
Head Protector final Assembly
.
®
corners
®
9004 Helmet,
Page 16 of 52
8972330.FTSIM_rev00
Publicité
