Publicité
Les langues disponibles
Les langues disponibles
10. Prior to
re-installing the Mustache Foam,
(see Fig. 33).
11. Align the thicker edge of the Mustache Foam with the center of the Goggle
thicker edge of the Mustache Foam is also aligned with the edge of the Mustache Velcro
12.
Firmly press the Mustache Foam against the Mustache Velcro
maintain the thicker edge of the Mustache Foam in place to properly align it with the Mustache Velcro
(see Fig. 34).
Fig. 33 - Center of the Goggle frame
13. To complete the reassembly of FX
the center mark of the Fabric Cover by locating the silver dot. This can be found at the chin area with the embossed
dot, which is also located at the chin area on the Face Shield. Join the Velcro Loop with the Velcro Hook by following
the edge of the Velcro Hook, which is permanently affixed onto the Face Shield. To finalize the reassembly, make
sure the Fabric Cover follows the curvature of the Face Shield and that there are no ripples in the fabric.
14. Join the Velcro Loop with the Velcro Hook by following the edge of the permanently affixed Velcro Hook onto the
Face Shield. To finalize the reassembly, make sure the Fabric Cover follows the curvature of the Face Shield and
that there are no ripples in the Fabric (see Fig. 37, 38, 39 and 40).
Fig. 37
15. Ensure sure that all components are properly assembled and secured before using the FX
protector.
© 2022 General Dynamics-OTS Canada
bend the
®
9004 Helmet, Head Protector, install the Fabric Cover (8972246SP) by aligning
Fig. 35
Fig. 38
Registered trademarks of General Dynamics Ordnance and Tactical Systems-Canada Inc. are denoted by
Mustache Foam with your fingers and join both
®
Hook with your fingers. For maximum comfort,
Fig. 34 - Mustache Velcro
Fig. 36 - Embossed dot (Face Shield)
Fig. 39
www.simunition.com
frame (see Fig. 33). Make sure that the
®
Hook (see Fig. 34).
Hook edge
®
Silver Dot
(Fabric Cover)
Fig. 40
®
9004 Helmet, Head
.
®
ends together
®
Hook edge
Page 13 of 52
8972330.FTSIM_rev00
Publicité
