General Dynamics SIMUNITION FX 9004 Guide D'utilisation page 5

®
Donning the FX 9004 Helmet, Head Protector
1. Open the back flap by separating the Velcro
2. Hold both ends of the back flap with your hands and
place your chin first into the FX
Head Protector (see Fig. 4). Put the FX
Helmet, Head Protector over your head. Ensure
that the elastic's suspension bands (2) are well-
adjusted to your head. Ensure that your nose
bridge is well-adjusted with the nose receptacle of
your goggles.
3. Attach both ends of the back-flap Velcro
Fig. 5 and 5a). Ensure that your FX
around the nose bridge and face, which will help prevent fogging.
Fig. 5 – Attach both ends of your FX
back flap Velcro ® fastening by overlapping the Velcro.
4. Then, make sure that the textile cover (front & sides)
is properly adjusted over your shoulders (see Fig. 6).
®
Note: The FX 9004 Helmet, Head Protector must be worn with FX
®
with the FX 9004 Helmet, Head Protector.
© 2022 General Dynamics-OTS Canada
®
.
®
9004 Helmet,
®
9004
®
fastening by overlapping the Velcro
®
9004 Helmet, Head Protector's back flap is tight to get a good foam seal
® 9004 Helmet, Head Protector's
®
Registered trademarks of General Dynamics Ordnance and Tactical Systems-Canada Inc. are denoted by
Fig. 4 – Place your chin first into the
FX
Fig. 5a – Hook and loop attachment of your
Fig. 6 – Adjusting the FX
®
Throat Collar OSFA (8971764). This item is not included
www.simunition.com
9004 Helmet, Head Protector.
®
®
hook and loop attachment (see
FX ® 9004 Helmet, Head Protector
® 9004 Helmet,
Head Protector's textile
.
®
Page 5 of 52
8972330.FTSIM_rev00