General Dynamics SIMUNITION FX 9004 Guide D'utilisation page 12

6. Align the edges (see Fig. 26) of the bended forehead foam from the center point on the Velcro
press the Forehead foam against the Velcro
Fig. 26 - Face shield's foam alignment forehead edges
7. Prior to re-installing the Forehead Close Cell Foam onto the Frame Goggle, identify the thinner edge of the Forehead
Foam (see Fig. 28). Then, bend the Forehead Foam with your fingers and join both ends together (see Fig. 29).
8. Align the thinner edge of the Forehead Foam right in the center of the Goggle frame (see Fig. 30). Make sure that
the thinner edge of the Forehead Foam is also aligned with the edge of the Forehead Velcro
and 32).
9. Then, firmly press the Forehead Foam against the Forehead Velcro
make sure to maintain the thinner edge of the Forehead Foam in place to properly align it with the Forehead Velcro
Hook edge (see Fig.32).
Fig. 28 - Thinner edge
© 2022 General Dynamics-OTS Canada
Fig. 31
Registered trademarks of General Dynamics Ordnance and Tactical Systems-Canada Inc. are denoted by
®
Hook with your fingers (see Fig. 27).
®
Fig. 29
Fig. 32 - Forehead Velcro
www.simunition.com
Fig. 27
Hook with your fingers. For maximum comfort,
Fig. 30 - Center of the Goggle frame
® Hook edge
.
®
®
Hook, then firmly
®
Hook (see Fig. 31
®
Page 12 of 52
8972330.FTSIM_rev00