General Dynamics SIMUNITION FX 9004 Guide D'utilisation page 19

9. Prior to re-installing the chin foam part, bend the chin foam with your fingers and join both ends together.
10. Align the bent center joint with the marked line, located on the Face Shield around the chin area (see Fig. 61).
11. Firmly press the chin foam against the Velcro
12. Similarly, bend the forehead foam with your finger and join both ends together (see Fig. 63).
13. Then, align the edges (see Fig. 64) of the bent forehead foam from the center point on the Velcro
press the forehead foam against the Velcro
Fig. 64 - Face shield's foam alignment forehead edges
14. Prior to re-installing the forehead close-cell foam onto the frame goggle, identify the thinner edge of the forehead
foam (see Fig. 66). Then, bend the forehead foam with your fingers and join both ends together (see Fig. 67).
15. Then, align the thinner edge of the forehead foam right in the center of the goggle frame (see Fig. 68). Ensure that
the thinner edge of the forehead foam is also aligned with the edge of the Forehead Velcro
70).
16. Then, firmly press the forehead foam against the Forehead Velcro
keep the thinner edge of the forehead foam in place to properly align it with the Forehead Velcro
Fig. 70).
© 2022 General Dynamics-OTS Canada
Fig. 61 – Face Shield marked
center line at the chin area
Registered trademarks of General Dynamics Ordnance and Tactical Systems-Canada Inc. are denoted by
®
Hook with your fingers (see Fig. 62).
®
Hook with your fingers (see Fig. 65).
®
www.simunition.com
Fig. 62
Fig. 63 - Center Velcro Hook dot
Fig. 65
®
Hook with your fingers. For maximum comfort,
.
®
®
Hook and firmly
Hook (see Fig. 69 and
®
Hook edge (see
Page 19 of 52
8972330.FTSIM_rev00