Adjusting The Backlash - Reely Stagger 4RW RtR Notice D'emploi

Buggy de sable électrique, échelle 1:10
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

d) Adjusting the backlash
The manufacturer has already preset the backlash. As a rule, no correction is required.
However, vibrations may cause the fixing screws in the engine to become loose after prolonged use. If this occurs, the
screws must be tightened and you must check that the backlash is correct.
Pull out the two clips (A), then remove the dust cover (B).
Basically, the distance between the main gear (C) and the
engine pinion (D) must be as small as possible, but with-
out the gears running strictly.
Loosen the upper fixing screw (E) of the engine a little bit.
Gently slide the engine with the engine pinion (D) in the
direction of the main gear (C).
The engine must not shake; the fixing screw
should only be loosened enough to allow the
engine to move.
The engine pinion and the main gear will now be engaged
without backlash. However, this is not optimal for the ser-
vice life of the gears!
Place a strip of thin paper (F) between the main gear (C)
and the engine pinion (D). Turn the main gear so that the
paper strip (max. 80 g!) is pulled between the two gears.
The pressure of the paper pushes the electric engine by
the required amount.
Tighten the fixing screw (E) on the engine.
When you turn the main gear in the other direction to re-
move the strip of paper (G), both gears should be at the
correct distance to one another.
Ideally, the engine pinion should be as close as
possible to the main gear whilst ensuring that
the cogs do not touch, as this makes the gears
too tight.
If the gears (engine pinion and main gear) are
too far apart, the cogs on the main gear will be
damaged by the engine pinion after just a few
seconds, which will void the warranty/guaran-
tee!
However, if the engine pinion presses against the main gear (i.e. there is no clearance between the cogs),
this will decrease performance, increase power consumption (the engine requires lots of power to turn the
main gear) and lead to premature wear.
60

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

2141862

Table des Matières