Controlling The Vehicle - Reely Stagger 4RW RtR Notice D'emploi

Important!
When using a LiPo drive battery, check the speed controller settings to confirm that undervoltage protection
is enabled (normally 3.0 V/cell). If undervoltage detection is switched off, the LiPo battery may be perma-
nently damaged due to overdischarge.
When using a NiMH battery, disable undervoltage detection or configure a lower voltage setting (see sec-
tion 10 b).
The LED on the speed controller goes out in the neutral position or lights up red when driving forwards and backwards.
A green LED lights up as well when driving forward and at full throttle.
g) Controlling the vehicle
Close the body, see section 9. a). Place the vehicle on the ground. Do not reach into the engine or hold the wheels.
1. Release the throttle/brake lever (move it to the neutral position). The vehicle should roll to a halt or stay stationary
(if necessary, adjust the throttle trim on the remote control).
2. Slowly pull the throttle/brake lever towards the handle to make the vehicle move forwards.
3. Move the throttle/brake lever away from the handle without a pause to make the vehicle move forwards and brake
(the vehicle decelerates quickly rather than coming slowly to a standstill).
4. Move forwards, brake and then drive in reverse: Push the throttle/brake lever away from the handle (braking)
without pausing; if the vehicle remains stationary, move the throttle/brake lever to the neutral position briefly (ap-
prox. 1 second), then push the throttle/brake lever away from the handle (vehicle will now reverse)
Move forwards
48
Brake If the vehicle is station-
ary , wait for a moment
(one second)
Reverse