Control Connection Diagram - LiftMaster LOGIC 5.0 T Manuel D'installation

CONTROL CONNECTION DIAGRAM

IMPORTANT NOTES:
1. The 3-Button Control Station provided must be connected for operation.
2. If a STOP button is not used, a jumper must be placed between terminals 4 and 5.
3. When adding accessories, install them one at a time and test each one after it is added to ensure proper installation and operation
with the Commercial Door Operator.
3 BUTTON STATION OR 3 POSITION KEYSWITCH WITH SPRING RETURN TO CENTER AND STOP BUTTON
STANDARD
7 6
10
(RED)
Open
Maintenance
Alert LED
Close
Stop
(WHITE)
7 6
Open
Close
TIMER DEFEAT SWITCH
11 12
Keyswitch
NON-MONITORED EDGE SENSOR TO REVERSE OR STOP
NOTE: 11 and 4 are both the same common. Either is acceptable.
01-39130D
4 5
(RED)
Maintenance
Alert LED
(WHITE)
NOTE: Stop circuit must be wired in series for all stop
buttons to function. This may require removal of factory
installed jumper bar in the 3-button station.
2 BUTTON STATION OR 3 POSITION KEYSWITCH WITH SPRING RETURN TO CENTER
4 STANDARD
D1 & E2
MODE ONLY
See note 2.
1 BUTTON STATION OR ANY AUXILIARY DEVICE
OPEN / CLOSE
1 4
B2, T, TS & FSTS
11 8
Edge Sensor
Wi-Fi® is a trademark of Wi-Fi Alliance®
App Store and the Apple and App Store logos are trademarks of Apple Inc.
Google Play and the Google Play logo are trademarks of Google LLC
2 OR MORE
7 6 4 5
10
Open Open
Close Close
Stop Stop
7
MODE ONLY
See note 2.
Remove Factory Installed Jumper when Interlock is Used
2
© 2022, LiftMaster
All Rights Reserved
KEY LOCKOUT
(RED)
Maintenance
Alert LED
(WHITE)
2 OR MORE
6 4
Open Open
Close Close
RADIO CONTROLS
(WH) (OR) (YE)
EXTERNAL
R1 R2
R3
RADIO RECEIVER
NOTE: 32 Vdc power supplied from white and yellow
wires located within the electrical box.
EXTERNAL INTERLOCK
3
ONE All Wiring Types
7 6 4 5
10
Open
Close
Stop
Keyswitch
D1 & E2
MODE ONLY
See note 2.
2 3
2 OR MORE