Selve SE Pro-RC Serie Notice De Réglage page 66

GB iveo initial operation/Setting by radio
7.1.2. Manual setup-mode, deletion and manual setting of the end positions
 in operation bottom position, top position
When the movement is interrupted once, the system is in manual setup-mode.
In manual setup-mode, the lower end position must be set and stored first. Afterwards,
the upper end position can be set and stored.
Caution!
Only connect the radio motor that you wish to program to the mains. It is not possible
to program more than one motor at the same time.
Setting with
transmitter
6 s
or
3 s
or
3 s
1 s
Drive
Connect to power.
Press the UP and DOWN buttons at the transmitter at the
same time. The transmitter is temporarily programmed into
the motor.
Press the STOP button of the transmitter for 6 seconds.
Move the motor to the lower end position with the UP or
DOWN button.
Press the STOP button of the transmitter for 3 seconds.
The correct rotation direction assignment will be carried out
at the end of the end position setting.
Move the motor to the designated upper end position.
Press the STOP button of the transmitter for 3 seconds.
The end positions are now set and the rotation direction
assignment is correct. Perform a test run.
Press the PROG button at the transmitter.
The transmitter is now permanently programmed.
66