Publicité
Les langues disponibles
Les langues disponibles
GB commeo initial operation/Setting by radio
Note for settings under point 6.2.: The motor must be selected for this setting with
a transmitter in SELECT mode (Status LED flashes slowly in orange). After completing
the setting, the motor is still selected (see point 6.).
6.2.1. Automatic setup-mode, deletion and automatic setting of the end positions
in operation bottom position, top stop/release
When the movement is interrupted twice during operation, the system is in automatic
setup-mode. Motor types SE Pro-RC will automatically find their stop positions. For
this, a motor must first move against the upper stop and then downwards until it
switches off automatically.
Operation
9 s
or
Auto-Stop top
and bottom,
keep motion button
pressed
Drive
Press the STOP button of the transmitter for 9 seconds.
Both limit positions already set will be deleted.
Note: Not required for the initial installation or after resetting
to factory defaults.
Move the motor upwards with the UP or DOWN button.
The motor moves against the upper stop and stops auto-
matically. The correct direction of rotation assignment has
been made.
Continue to keep the button pressed.
The motor automatically moves downwards after
1–2 seconds. Alternatively move the motor downwards
using the DOWN button.
Note: The motor can be moved upwards and downwards.
As long as the lower end position has not been found, the
downwards moving will be interrupted twice.
The motor will reach the lower limit and stops automati-
cally.
The end positions are now set and the rotation direction
assignment is correct. Perform a test run.
Note: The transmitter may not yet have been programmed.
See point 6.2.4. to program a transmitter.
58
Publicité
