Putting The Machine Into Service - Grillo FD 1100 4WD Emploi Et Entretien

STARTER: electric 12V.
TRACTION: hydraulic, 4 drive wheels (integral and permanent also in case of sharp bend).
DIFFERENTIAL LOCKING WITH PUSH BUTTON.
GEARBOX: hydrostatic transmission with 4 hydraulic engines on 4 wheels.
STEERING SYSTEM: hydraulic drive with steering wheel.
CLUTCH: electromagnetic for PTO, with magnetic blade brake.
SPEED: 0-15 km/h: continuous variation.
WHEELS: front 23 x 10.50-12; rear 18 x 8.50-8.
MOTORISED BAFFLE PROVIDES FULL AND EVEN GRASS CATCHER FILLING.
GRASS CATCHER: 900 litres.
DISCHARGE HEIGHT: 1900 mm, REAR PROJECTION: 300 mm.
LOADING ACCELERATOR: with floating fins, belt transmission and independent electromagnetic clutch, diameter
350 mm.
AUTOMATIC FEATURES: automatically disengaging blade and loading accelerator when the grass catcher is full.
BRAKE: drum service and parking brake.
HYDRAULIC DECK LIFTING AND BASKET EMPTYING.
SEAT: super comfort adjustable and sprung seat with arm-rests.
STEERING WHEEL: fixed on steering column with tilt adjustment.
STEERING RADIUS: 310 mm.
ACCESSORIES: cutting deck with collection 1320 mm, weight 170 kg.
HOURLY MOWING CAPACITY: 10.000 m
SIZE (with cutting deck):
Length: 3250 mm, Width: 1410 mm, Height: 1750 mm.
CLEAR SPAN FROM THE GROUND: 150 mm.
DISTANCE BETWEEN AXLES: 1230 mm.
WEIGHT (without cutting deck): 900 kg.
- Make sure the machine is complete and that it has not suffered any damage during transit.
- Check the levels of the engine oil (fig. 3, ref. C) and hydrostatic transmission (fig. 4).
- Check the tyre pressures:
Front wheels 23 x 12.00 - 12 (1.4 bar)
Rear wheels 18 x 8.50 - 8 (1.4 bar)
Deck wheels (1.5 bar)
- Check the battery voltage, it must not be less than 12.5 Volts; recharge if necessary.
If a dry battery has been supplied with separate acid, to put the machine into service proceed as follows:
-
1) pour in the acid and wait 2 hours;
2) charge the battery with a charger set to 12 Volts on a slow charge for 2 hours.
Caution, if this procedure is not observed this could lead to the battery deteriorating and the acid leaking out
during work.
BATTERY
Caution! The gases released by the battery are explosive, so keep it away from naked flames or sparks. Check the
level of the liquid at regular intervals and keep the terminals greased with Vaseline.
Important:
Do not invert the battery poles.
-
- Do not run the lawnmower without the battery, as it is equipped with a charge regulator.
Be careful not to cause any short circuits.
-
RUNNING IN - CAUTION!!
Change the engine oil and filter after the first 50 hours of work.
Check for oil leaks or loose screws, especially those that retain the blades and the wheels.
Adjust the tension on the PTO belts with the nut on the corresponding spring: the spring has to be adjusted at 75
mm of length (fig. 5, ref. A). Adjust the loading accelerator belt tension with the nut on the corresponding spring: the
spring has to be adjusted at 70 mm of length (fig. 6, ref. B).
Before turning on the engine always check that:
the radiator liquid is up to the level (fig. 7);
-
- the engine cooling intake grilles are clear (fig. 8);
- the engine oil is up to the level (fig. 14, ref. C);
- the hydraulic oil is up to the level (fig. 4);
the feed and reverse motion pedals (fig. 1 n° 1 e n° 2) are in the stop position;
-
- the PTO insertion button is in the neutral position (fig. 1 n° 27);
the air filter is clean (fig. 9);
-
Translation of the original instructions
2
/h

PUTTING THE MACHINE INTO SERVICE

INSTRUCTIONS FOR USE
7