Practical Use; Switching On/Off - Ivoclar Vivadent Quick Mode D'emploi

6. Practical Use

6.1 Positioning the swivel arm
Move the swivel arm (18) upward until the desired working
height is reached.
6.2

Switching on/off

Switching on:
Put On/Off switch (5) at the rear of the apparatus on position 'I'.
The stand-by indicator (2) lights up and the unit is ready for use.
Should this not be the case, please read Chapter 8.
Switching off:
Put On/Off switch (5) on position '0'.
12
6.3 Light-curing
Step 1
Reach into the sensor range with the hand or other object. This
will activate the lamp.
Step 2
Move object to be cured into the light
observing the recommended distance and curing time. Please pay
attention to the
signals of the timer.
Step 3
Remove hand or object from the sensor range after the indicated
curing time (see Instructions for Use of the respective material).
The lamp automatically switches off four seconds after removing
the hand or object.
The unit is not designed for continuous operation. For
that reason, it automatically switches off after
maximally 60 seconds. If the swivel arm is moved down-
wards to a closed position when the unit is on stand-by,
the lamp automatically switches on. Therefore, the
On/Off switch has to be set on position '0' if the unit is
being closed.
If the unit is no longer used, it should be allowed to cool, and
then switched off.
Make sure not to switch off the unit while it is still
warm, since the fan is also turned off. This may then
lead to overheating of the unit.
Please refer to the Instructions for Use of the individual
materials for the recommended curing times.