Binding Function - Reely SKY XL 20 91 06 Notice D'emploi


14.

Binding Function

Transmitter and receiver are already aligned with each other and can be used at once.
Binding only needs to be performed again after replacing the transmitter or receiver or to remove malfunctions.
Since other manufacturers use different encoding and decoding methods, transmitter and receiver cannot be com-
bined and operated with products of other manufacturers.
Re-establishing the binding:
To recover binding between the transmitter and receiver, the flight battery must be plugged off and the transmitter must
be switched off.
Press and hold the binding button at the model (1).
Keep the binding button pressed and connect the flight bat-
tery to the receiver/controller component. The LED at the
receiver/controller component (2) will first flash and then light
permanently. This does not indicate present binding at this
point.
Press and hold the binding button at the transmitter (3).
Switch on the transmitter with the function switch (figure 1,
item 6) with the binding button pressed (3) and keep the
button pressed for another 3 - 5 seconds.
Then remove the flight battery from the receiver/controller
component and switch off the transmitter.
Binding is now complete. After the next switching on, the
control signals transmitted will be received again and the
remote control is operational.
For a better overview, the mechanics are shown removed from the fuselage in figure 25. Generally, it is
easily possible to press the model's binding button even with the mechanics installed.
60
Figure 25