Binding Function - Reely SKY EC 135 Notice D'emploi


14.

Binding Function

Transmitter and receiver are already aligned with each other and can be used at once.
Binding only needs to be performed again after replacing the transmitter or receiver or to remove malfunctions.
Since other manufacturers use different encoding and decoding methods, transmitter and receiver cannot be combined
and operated with products of other manufacturers.
Re-establishing the binding:
To recover binding between the transmitter and receiver,
the flight battery must be plugged off and the transmitter
must be switched off.
Slide the binding switch (1) on the receiver/controller
component (2) in the front position.
Connect the flight battery to the model. The control LED at
the receiver/controller component (3) starts flashing quickly.
Press and hold the binding button at the transmitter (4).
Switch on the transmitter with the function switch (5) with
the binding button pushed. The control LED at the receiver/
controller component remains lit for a short time and starts
flashing slowly after about 2 seconds.
Then disconnect the flight battery from the receiver/controller
component and switch off the transmitter.
Slide the binding switch on the receiver/controller component
in the rear position.
Binding is then completed and the receiver/controller
component should react to the transmitter's control signals
again after the next activation.
If this is not the case, repeat binding.
Figure 21
For a better overview, the canopy has been removed in the upper illustration in figure 21.
52