English
follow instructions
3.
CLEAN BREWING UNIT
3.1.
Cleaning enabling
Deact.
Act.
3.2.
Cleaning delay
10....240
4.
WATER FILTER
4.1.
ALARM THRESHOLD
4.2.
STOP THRESHOLD
4.3.
ACTUAL COUNTER
5.
Counters
5.1.
TOTAL COFFEE
5.2.
TOTAL WATER
96
(contact an authorised service centre for detailed information on the tablets).
Procedure:
The process starts from "GROUP RINSING"
Press the "Enter" button;
the display shows "PUT THE TABLET INTO THE GROUP"
Remove the brew group;
the display shows "INS. BREW GROUP"
Insert the tablet into the brew group and put the brew group back in its place;
the display shows "CLOSE SERV. DOOR"
Close the door;
the display shows "RINSING"
The machine starts performing a wash cycle. When the cycle is complete the display shows
"REMOVE THE GROUP AND RINSE IT WITH WATER"
Remove the brew group;
the display shows "INS. BREW GROUP"
Wash the group under running water.
Put the brew group back into place;
the display shows "CLOSE SERV. DOOR"
Close the door;
the display shows "RINSING COMPLETED PRESS OK"
Press the "OK" button to definitely quit the menu so that the machine is ready for use
This function allows dispensing a minimum quantity of hot water (about 5 cc) to avoid the
building up
of deposits in the coffee dispensing spout.
The wash cycle is performed automatically after the programmed time (20 - 240 minutes)
from the last dispensing.
By confirming:
"DEACTIVATE":
the machine does not perform the wash cycle
"ACTIVATE":
the machine performs the wash cycle.
It sets the delay time of the dispensing spout wash from the last dispensing.
The "Descaling" warning is intended for the maintenance of the descaling devices (resin
softeners or others).
The installer or the company in charge of servicing the descaling device can program
the quantity of water necessary to perform the system regeneration.
Warning! In case ion-resin systems are used, it is extremely important to perform a proper
maintenance
since used resins can cause the treated water to become not-drinking.
The "DESCALING" warning is shown both when the machine indicates that descaling is
required,
and when it blocks definitely.
In the last case the "DESCALING" warning is shown together with the "Descaling message"
These two functions represent respectively the total of the coffee brewing cycles and the total
of the hot water dispensing cycles.
If the automatic dosing of hot water is disabled (see function "Hot water programm. " ),
a cycle for each activation of the solenoid valve will be counted.
NOTE:
Both functions are for reference purpose only and cannot be reset.