Publicité
Les langues disponibles
Les langues disponibles
English
Make sure that the power
cord
plug
reachable after installation.
The electric socket or the
all-pole switch which the
appliance is connected to
must be easily accessible
for the user, so that the
user will easily disconnect
the appliance from the
electric
necessary.
If damaged, the power
cord must be replaced by
the
Technician only.
• Insert the electric power cord into the proper hole (see
chapter "Unpacking and Positioning").
• Connect the appliance to the mains by means of the
power cord.
NOTE
In case of plants with a 400 V two-phase current, use the
two phases so as to supply the machine with a 230 V
single-phase current. Ask for the special installation kit
(code 1034.R09) for the 230 V single-phase connection.
80
is
easily
mains
when
Maintenance
- Power cord type H07RNF section 4x2.5 mm2
N
Neutral – Blue
L1
Phase – Brown
L2
Phase – Black
T
Ground – Yellow/green
- Connection of the two phase power supply plug 400 V 2
N~
CH Switzerland
CEI in compliance with CEI standards
Depending
regulations in force in the
Country where the machine
is being used, the cable
connecting to the power
supply has to be pre-set or
equipped with an all-pole
switch (with a minimum
contact opening of 3 mm),
or with a plug complying
with the same regulations.
on
the
Publicité
