Saeco Idea RST CAP020/A Mode D'emploi Et D'entretien page 100

English
9.3 Programmed Automatic
Start-up
This start-up is possible when the machine is in "STANDBY"
mode and the function "AUTOMATIC START-UP" is active.
The machine will switch-on at the programmed time.
9.4 Stand-by Temporary Start-up
Manual switching-on when the machine in "STANDBY" mode.
This is possible by pressing the button shown in the figure for 3
seconds.
The machine will automatically
"STANDBY" mode after 30 minutes from the last
operation, if still within the programmed standby time.
9.5 Beverage Selection
The conditions necessary to select a beverage are the
following:
• the appliance has reached the set temperature after the
start-up. Otherwise, the display will show the message
"HEATING";
• There is no error condition that prevents brewing
beverages. Otherwise, the display will show the error
message;
• the selected beverage is enabled. Otherwise, the keypad
shows the beverage off icon;
When dispensing
beverage:
• The display shows the dispensing beverage icon.
100
go back to the
a