Operation; On/Off Safety Switch; Raising/Lowering The Blade - Evolution FURY 5-XS Instructions D'origine

www.evolutionpowertools.com
Note: The 'free' port of the 2 way connector can be used to
attach a workshop dust extraction machine to this Evolution
machine. If such a machine is connected to this Table Saw
follow the Instructions provided by the supplier/manufacturer
of the dust extraction equipment.
Use of such equipment will ensure that the workplace is kept
clean and tidy, and that dust is kept to a minimum.

OPERATION

ON/OFF SAFETY SWITCH

WARNING: Before operating the switch make sure that the
blade guard is correctly installed and operating properly.
To start the machine, lift the safety cover (Fig. 15) to reveal
two buttons.
• Push the 'ON' button to start the machine.
• Push the 'OFF' button to stop the machine.
WARNING: Never start the machine until all safety checks and
procedures have been carried out.

RAISING/LOWERING THE BLADE

WARNING: Only make adjustments to the machine when the
machine is switched OFF and the blade is stationary.
Note: This machine is equipped with a dual function
hand- wheel (Fig. 16) in its 'normal' (outer) position this
hand-wheel is used to raise or lower the blade.
When the hand-wheel is pushed in against its bias spring a
cog engages with a curved toothed rack incorporated into the
machines main body. This allows the hand-wheel to be used to
adjust the tilt/bevel angle of the blade
To raise or lower the blade:
• Ensure that the hand-wheel is in the 'normal' (outer)
position.
• Turn the hand-wheel clockwise to raise the blade.
• Turn counter clockwise to lower the blade.
Fig. 13
Fig. 14
Fig. 15
Fig. 16
17
EN
FR