Installing The Batteries In The Remote Control - afx light MOVING-CLUB-KALEDO Manuel D'utilisation

MENU
CH28
DMX Mode
CH23
PAN degree
Scan Degree
TILT degree
Version V1.0--VXX
DMX channel chart: please refer to LAST page
IR REMOTE CONTROLLER
Please operate the remote control within a distance of 6m and 30° between the remote and the
appliance. Aim the remote at the sensor. Remove all obstacles between the remote and the sensor.
The remote control might not work properly if the sensor is exposed to strong sunshine.
If the remote control doesn't work properly, please check the batteries.

INSTALLING THE BATTERIES IN THE REMOTE CONTROL

• Place the remote face down on a flat surface.
• Push the compartment cover into the direction of the arrow.
• Slide the battery compartment open.
• Remove the old battery and install the new one (CR2032) with the plus (+) sym-
bol facing up.
• Gently slide the battery compartment closed. It locks automatically.
RECOMMENDATIONS FOR BATTERIES
This symbol indicates that used batteries should not be disposed of with household waste but deposed correctly in accordance with
your local regulations..
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or corrosion.
ATTENTION: Danger of explosion if battery is incorrectly placed. Only replace by the same or equivalent type.
WARNING :Do not swallow the battery. Danger of chemical burns. Keep new and old batteries out of the reach of children.
If the battery compartment doesn't close properly, stop using the product and keep it out of the reach of children.
If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body, contact immediately a doctor.
REMOTE CONTROL
1. Press 3x the SPOT button to activate the RF function on all SPOT fix-
tures (n.a. to this unit)
2. Press 3x the BEAM button to activate the RF function on all BEAM
fixtures (n.a. to this unit)
3. Press 3x the WASH button to activate the RF function on all WASH
fixtures operated by the remote control. Please note: To operate the
MOVING-CLUB-KALEDO via this remote control, you have to press
3x the WASH button.
4. Press 3x the PAR button to activate all PAR fixtures operated by the
remote control (n.a. to this unit)
5. Press DIMMER and adjust the brightness of the effect via the + or -
buttons.
6. Press STROBE to turn on the Strobe effect. Adjust the speed of the
strobe via the +/- buttons.
7. Press  to lower the speed of the built-in program or the mic sensi-
tivity.
8. Press  to increase the speed of the built-in program or the mic sensitivity.
9. 1-9 number buttons: In auto and sound-controlled mode, press AUTO first and then select a
program number; in Dimmer and Strobe mode, select the colour associated to the button.
10. Reset all. Exit the modes you have selected before.
11. Press DMX to select the wired DMX signal as signal source.
630°/540°/360°
270°/180°/90°
www.afx-light.com
Description
Standard mode
Basic mode
Select Pan Degree
The default is 540°
Select Tilt Degree
The default is 270°
Software Version: V1.0--VXX
Spot Beam
Dimmer Strobe
1 2
4 5
7 8
DMX
WDMX
Wash Par
‫ا‬ᐊᐊ ᐊ ‫ ا‬ᐊ
+
3
-
6
9
Auto Sound
5 EN