Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
12. To select a RGBW colour, press DIMMER button first and then a colour button.
13. When you press the DIMMER button, you will disconnect the DMX console signal.
14. Press AUTO to run a built-in program
15. Press SOUND to run a sound-controlled program
Tips
When the unit is in remote controlled mode (RF function), the DMX signals are not active. Each
remote control can control only fixtures operating in the same mode at the same time.
When DIMMER and STROBE are enabled in Wash mode, you need to press the number button to
light up the corresponding colour. In SPOT and BEAM mode, the number buttons can only switch
the colour wheel but don't correspond to the colour of the button.
To turn off the RF function, following options are possible:
1.
For WASH devices press SPOT, BEAM, PAR, DMX or WDMX button. The signal LED on the LCD
display will turn to green.
2.
Press the MENU button on the main display panel of the device.
CLEANING AND USING FREQUENCY OF PRODUCT
Please make sure that the light is power off before dismantling or maintaining, it's very important
to keep the light clean. Frequent cleaning will ensure maximum brightness output, but also prolong
the life time. It's suggested to use the high quality, professional glass detergent and soft cloth to
clean the light. It's not allowed to use alcohol or chemical solvent. The inner part of the light should
be cleaned by vacuum cleaner at least once a year. When the light doesn't work, please check if the
fuse is burnt out or not. If it is, the same fuse should be replaced, find out the faulty and restart the
light. But please note the repair must be handled by professional.
PHOTOMETRIC DIAGRAM
Distance
1m
3m
(LUX)
5967
R
600
G
5962
615
B
7922
805
7200
760
W
RGBW
27130
2750
TECHNICAL SPECIFICATIONS
EN
6
5m
7m
26°
218
216
277
266
1049
© Copyright LOTRONIC 2022
Publicité
Table des Matières
