afx light MOVING-CLUB-KALEDO Manuel D'utilisation page 3

down before replacing or servicing.
• DO NOT OPEN the unit within 5 minutes after switching off.
• In the event of a serious operating problem, stop using the unit immediately. Never try to repair
the unit by yourself. Repairs carried out by unskilled people can lead to damage or malfunction.
Please contact the nearest authorized technical assistance center. Always use the same type of
spare parts.
• Make sure the power cord is never crimped or damaged.
• Avoid direct eye exposure to the light source while it is on as sensitive persons may suffer an
epileptic shock (especially meant for epileptics)!.
• The product is for decorative purposes only and not suitable as a household room illumination.
• If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced
by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
• The lenses, housing or ultraviolet filter must be replaced if they are visibly damaged.
• Please note that the lamp of this device cannot be replaced. If the lamp is faulty, the unit must
be discarded
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect
device shall remain readily operable.
INSTALLATION
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly
fixed to avoid vibration and slipping while operating. Always ensure that the structure to which you
are attaching the unit is secure and is able to support a weight of 10 times of the unit's weight.
The installation must always be secured with the supplied safety rope.
Never stand directly below the device when mounting, removing or servicing the fixture.
CLAMP MOUNTING
The unit is supplied with a mounting bracket assembly that is securely
fastened to the bottom of the base and contains also a safety rope rigging
point. Fasten an appropriate clamp via an M10 screw to the supplied ome-
ga bracket. Fasten the omega bracket assembly to the base of the moving
head by turning the screws by 1/4. Attach the supplied safety rope to the
eyelet on the base.
POWER SUPPLY AND SIGNAL CABLE CONNECTION
POWER IN
Fuse
1. Mains Power connection
The exclusive plug should be used between the connection of unit and
power. Please ensure that the rated voltage and frequency are accordance
with the power supply. The required input voltage and frequency are: 90-
240V~ 50/60Hz
We suggest that every light has an independent switch so that you can
turn on or turn off the light randomly.
Note: the ground wire (yellow/green double-colour wire) must be safely connected, the electrical installation
must be in accordance with the related standards
DMX OUT
DMX IN
Power switch
www.afx-light.com
Safety clamp
Omega bracket
1/4 Turn 1/4 Turn
Safety cable
3 EN