Abus FUMO50110 Manuel D'installation Et D'utilisation page 72

Installation
Hybrid mo- Secvest alarm panel pro-
dule connec- gramming
tions
C3 (OP3) Output 403
(Example vari- Output type:
"Intruder alarm"
ant)
Output 402
C2 (OP2)
Output type:
(Example vari-
"Enabled"
ant)
Output 401
C1 (OP1)
Output type:
(Example vari-
Full set ready
ant)
Z10
Zone 410
(Example vari-
Zone type:
ant)
"Key switch duration"
Z9
Zone 409
(Example vari-
Zone type: "Tamper"
ant)
Z8
Zone 408
(Example vari-
Zone type: "Tamper"
ant)
The hybrid module was designed so that changes to the zone status are detected if
they last at least 400 ms (EN50131-1 Chapter 8.9.1 and EN50131-3 Chapter 8.9 and
Danger
Annex B).
Break-in, intrusion and tampering signals must last at least 400 ms.
The hybrid module was designed so that changes to the fault status (fault signals) are
detected if they last at least 10 s (EN50131-1 Chapter 8.9.1 and EN50131-3 Chapter
8.9 and Annex B).
72 | EN
Note 1)
Note 1)
Note 1)
Notes 2) 3)
Programming is per-
formed on the alarm
panel
Notes 2) 3)
Programming is per-
formed on the alarm
panel
Notes 3) 4)
wAppLoxx Control pro-
wAppLoxx
gramming
Control
connections
In 3 Alarm input
Alarm panel is in the alarm
state
In 2 Arming input
Acknowledgement of ena-
bling from alarm panel
In 1 Ready
for arm
Relay 1 Arming output
Relay 2 Create event
Event type: "Tamper"
Note 1)
Note 1)
Note 1)
Note 2)
Note 2)