Stanley SM18 Mode D'emploi page 26

ENGLISH (
Original Instructions)
NOISE
The declared noise emission values stated in the technical
data and the declaration of conformity have been
measured in accordance with a standard test method
provided by EN 62841 and may be used for comparing one
tool with another. The declared noise emission value may
also be used in a preliminary assessment of exposure.
WARNING! The noise emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which
the tool is used. The noise level may increase
above the level stated.
When assessing noise exposure to determine safety
measures required by 2002/44/EC to protect persons
regularly using power tools in employment, an estimation
of noise exposure should consider, the actual conditions of
use and the way the tool is used, including taking account
of all parts of the operating cycle such as the times when
the tool is switched off and when it is running idle in
addition to the trigger time.
EC declaration of conformity
MACHINERY DIRECTIVE
SM18 - Mitre Saw
STANLEY declares that these products described under
"technical data" are in compliance with: 2006/42/EC, EN
62841-1: 2015, EN 62841-3-9: 2015+A11:2017.
These products alsoV comply with Directive 2014/30/EU
and 2011/65/EU. For more information, please contact
STANLEY at the following address or refer to the back of
the manual.
The undersigned is responsible for compilation of the
technical file and makes this declaration on behalf of
STANLEY.
Director – Outdoor Products Group
Egide Walschaertsstraat14-18, 2800 Mechelen,
26
Becky Cotsworth
STANLEY FATMAX Europe,
Belgium
04.2019
TWO YEAR WARRANTY
If your STANLEY product becomes defective due to faulty
materials or workmanship within 24 months from the date
of purchase, STANLEY guarantees to replace all defective
parts
free of charge or – at our discretion – replace the unit free
of
charge provided that:
• The product has not been misused and has been used
in accordance with the instruction manual;
• The product has been subject to fair wear and tear;
• Repairs have not been attempted by unauthorized
persons;
• Proof of purchase is produced;
• The STANLEY product is returned complete with all
original components;
• The product hasn't been used for hire purposes.
If you wish to make a claim, contact your seller or check
the location of your nearest authorised STANLEY repair
agent in the STANLEY catalogue or contact your local
STANLEY office at the address indicated in this manual.
A list of authorised STANLEY repair agents and full details
of our after sales service is available on the internet at:
www.2helpU.com