Charging Instructions - COOK Medical DP-M350 Mode D'emploi

ENGLISH
Charger for Blood Flow Monitor - DP-M350
Instructions for Use
Read these instructions before using the charger
This product is designed for indoor use only and should not come into contact with water or
dust. To prevent overheating the product should not be covered during use.
The mains socket should be easily accessible. In the event of operational error, the plug
should be immediately removed from the socket.
The product contains dangerous voltages and the cover should not be removed. All service
or maintenance work should be carried out by qualifi ed personnel who can get assistance by
contacting the manufacturer's agent.
The unit is double insulated (in insulation class II).
System: The Charger for Blood Flow Monitor DP-M350 (DP-M350-CHG1) is to be used with the Cook Doppler
Blood Flow Monitor (DP-M350).
Technical specifi cation: See product labeling.

CHARGING INSTRUCTIONS

1. Do not connect the charger to the mains before it is connected to the monitor.
2. Connect the charger to the mains.
3. When charging is complete, disconnect from the mains before removing monitor connections.
CHARGE INDICATOR (LED)
RED – Indicates battery pack is being charged.
GREEN – Indicates battery pack is fully charged
USE OF ALTERNATE (SUPPLIED) PLUG ADAPTERS
1. The charger (DP-M350-CHG1) for the Doppler Flow Monitor (Model: DP-M350) is supplied with various
plug adapters that are confi gured to connect to regional mains input connections. The charger is designed
to operate at input voltages of 100-240VAC 50-60Hz max 0.35A without any action on the part of the user.
2. Prior to using the charger, confi rm that the voltage at the mains is compatible with the unit.
3. Select the appropriate plug adapter for the local mains.
4. If the appropriate plug adapter is not connected to the primary charger unit, remove the existing plug
adapter by pressing on the grated area directly beneath its output plugs while pushing in the direction of
arrow (Figure 1a) or by placing fi ngers directly below the elevated plug adapter and pushing upward and
away from the cable (Figure 1b). The attached plug adapter will detach and slide upward and off the primary
charger unit.
5. Orient the appropriate plug adapter so that it is appropriately in-line with the receiving channel of the
primary charger unit (Figure 2).
6. Slide the plug adapter fully onto the primary charger unit (Figure 3).
7. Plug into mains as required.
150