Inserting And Removing The Batteries - Philips Respironics SimplyGo Manuel De L'utilisateur

Inserting and Removing the Batteries

Your SimplyGo device comes with one rechargeable lithium ion battery To
insert it correctly, follow these steps
1 Place your device in a well ventilated location and make sure it is turned
o
Note: The SimplyGo device is shipped from the factory with the battery
removed
Caution: Only remove the battery when the SimplyGo is turned o
Never remove the battery while the device is
operating
To remove the battery, insert your ngers into the
2
opening in the battery handle Steadily pull upward
on the handle until the battery is released from the
enclosure Continue to lift the battery until it is entirely
removed from the battery compartment If the device
has been operating, the surfaces may be warm to the
touch This is normal
3 Check the battery gauge (shown below) To do so, press the white button
(shown below) on the battery and watch how many LEDs light up If the
batteries are low, you can recharge them See the Charging the Battery
with AC Power Supply section
No. of LEDs Battery Charge
4 LEDs Light:
3 LEDs Light:
2 LEDs Light:
1 LED Lights:
1 LED Blinks
3 Times:
75% to 100% full
50% to 75% full
25% to 50% full
10% to 25% full
Battery is less than
10% full and
needs to be
recharged
SimplyGo User Manual
13