Philips Respironics SimplyGo Manuel De L'utilisateur page 21

Masquer les pouces Voir aussi pour Respironics SimplyGo:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SimplyGo User Manual
Caution: When the SimplyGo device is connected to a CPAP device, you can
only use the Continuous Flow operating mode
3. Sleep Mode Screen
The Sleep operating mode is similar to the Pulse Mode The device
detects when the user begins to take a breath using a more sensitive
detection level The SimplyGo then delivers a pulsed volume of oxygen
determined by the setting number During inhalation, a low amplitude
and longer pulse duration is used to make sleeping more comfortable If
no breath is detected for approximately 15 seconds, the system automati-
cally delivers a continuous flow of oxygen at a rate consistent with the
last used Continuous Flow mode setting, or a default of 20 LPM
Selecting the Operating Modes
You can use the Mode button (M) to select the device operating mode
To select your operating mode:
1
Press the Mode button
Note: If the device is operating and the screen is dark, the rst press turns
on the screen backlight In this case, press the button a second time
to select the mode The intensity of the backlighting can be either
increased or decreased Refer to the Turning the SimplyGo Device Of
section of this manual for more information
2
Continue pressing the Mode button to scroll through the Pulse, Continu-
ous Flow, or Sleep modes
3
When your desired mode appears in the display, stop pressing the button
and wait The display will return to the run time screen of the mode you
selected, and the device will operate in this mode
18

Publicité

Table des Matières
loading

Table des Matières