Operating The Simplygo Device And Changing Device Settings - Philips Respironics SimplyGo Manuel De L'utilisateur

Operating the SimplyGo Device and Changing
Device Settings
You can change all device settings using the buttons on the control panel
This includes starting the device, stopping it, silencing an alarm, and changing
oxygen ow
The alarm system should be veried before use by the equipment provider
and between users by service personnel in accordance with the SimplyGo
service manual However, the user may verify the functionality of the alarm
system as described below
To start your SimplyGo device, follow these steps.
1 Connect a nasal cannula to the patient cannula connector on top of the
device, as shown Ensure that the cannula is routed to prevent it from
being pinched or kinked to avoid a disruption of oxygen ow
Note: A standard single lumen nasal cannula and
tubing (not supplied) should be used to
deliver oxygen from the SimplyGo device
The device works with cannula tubing
up to 30 ft (9 m) Only Continuous Flow
mode should be used for cannula lengths
greater than 7 ft The proper placement and
positioning of the nasal cannula in the nose
is critical to the consistent operation of the SimplyGo
To start the device, press the Power button After the rst press, the
2
display screen and the 5 button backlights turn on and you will see a
screen similar to the one shown below
i
Tem
1
2
3
1
2
3
7
6
d
eSCriPTion
Push Power again to turn the device on
Total number of operating hours for the device
Indicates if the battery is being charged
SimplyGo User Manual
4
5
19