Traveling With Your System; By Motor Vehicle - Philips Respironics SimplyGo Manuel De L'utilisateur

Masquer les pouces Voir aussi pour Respironics SimplyGo:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Traveling With Your System

With your SimplyGo system and proper advance planning, you can enjoy
traveling within your community and beyond Before you leave, make sure
you pack the following:
Fully charged battery (and extra batteries for a long trip)
AC power supply and connector cord
DC power supply
Carrying case
Mobile cart
Also, be sure to take the telephone numbers of your home care provider and
physician in case of an emergency

By Motor Vehicle

Use the SimplyGo DC power supply to plug in your system using the vehicle's
cigarette lighter or DC power input Whenever the SimplyGo system is
running from a DC power source, the battery installed in your device will
begin recharging You can also use the SimplyGo device while it is running
from a DC power source
Caution: Make sure the vehicle has been started before plugging in your
DC power supply If you operate the SimplyGo system using the
DC power cord while the vehicle engine is turned o, you could
inadvertently drain the vehicle's battery
To run the device using DC power from an automobile or other motorized
vehicle, make sure the battery is installed Start the vehicle and connect one
end of the DC Power Cord to the device's power inlet and the other end into
the vehicle's DC electrical outlet
Because the amount of current available in the vehicle electrical system
is limited, the current available to charge the SimplyGo battery will be
determined by the operating mode of the device At high settings the
time required to charge the battery will be much longer and at the highest
settings, it may not charge at all
SimplyGo User Manual
39

Publicité

Table des Matières
loading

Table des Matières