Manual Function; Program Function - EUROM Alutherm Wi-Fi 1000 Manuel De L'utilisateur

CAUTION
When the device is turned on or off, it may emit a sound. This is material
expanding and shrinking during heating and cool-down.
CAUTION
The day and time settings will be lost if the device is switched off using the
ON/OFF switch or is unplugged.
1. Set the ON/OFF switch to the ON position
(Figure 17, pos. 1).
2. The display (Figure 17, pos. 2) will show OFF.
3. Press the ON/OFF button.
4. Press and hold the SET button until SET
appears on the screen.
5. Use the plus and minus button to select the
correct day and confirm with the SET button.
6. Use the plus and minus button to set the
correct time:
•
Hours, confirm with the SET button;
•
Minutes, confirm with the SET button.
7. Press the MOD button to choose the desired
function: manual or program.

Manual function

1. Set the capacity at which the heater will work using the plus and minus button. The 3
suns indicate whether the heater is set to low, medium or high capacity.

Program function

1. Set the desired temperature for the device using the plus and minus button. The device
automatically chooses the correct heating capacity to reach and remain the desired
temperature;
•
10 minutes after the desired temperature is reached the device will change from high
capacity to medium capacity;
•
each 5 minutes the device will check the ambient temperature and adjust the heating
capacity:
- if ambient temperature is more than 1 degree below desired temperature, the
device will increase capacity;
- if ambient temperature is within 1 degree below and 1 degree above desired
temperature, the device will heat keep current capacity ;
- if ambient temperature is more than 1 degrees above desired temperature, the
device will decrease capacity;
- if ambient temperature is more than 2 degrees above desired temperature, the
device will stop heating after 5 minutes.
In most cases the device will heat up the room slightly higher than the desired temperature.
To save energy costs, it is recommended not to set the desired temperature too high and
adjust accordingly.
Figure 17
35