Cleaning; Removal Of Iodine Compounds - Stryker Medical 6082 Rugged MX-PRO R3 Manuel D'utilisation

Hand wash all surfaces of the cot with warm water and mild detergent. Dry thoroughly. DO NOT STEAM
CLEAN, PRESSURE WASH OR ULTRASONICALLY CLEAN. Using these methods of cleaning is not rec-
ommended and may void this product's warranty.
Clean Velcro AFTER EACH USE. Saturate Velcro with disinfectant and allow disinfectant to evaporate. (Ap-
propriate disinfectant for nylon Velcro should be determined by the hospital.)
In general, when used in those concentrations recommended by the manufacturer, either phenolic type or
quaternary type disinfectants can be used. Iodophor type disinfectants are not recommended for use be-
cause staining may result. The following products have been tested and have been found not to have a harm-
ful effect WHEN USED IN ACCORDANCE WITH MANUFACTURERS RECOMMENDED DILUTION.*
TRADE NAME
A33
A33 (dry)
Beaucoup
Blue Chip
Elimstaph
Franklin Phenomysan F2500
Franklin Sentinel
Galahad
Hi−Tor
LPH
Matar
Omega
Quanto
Sanikleen
Sanimaster II
Vesphene
Quaternary Germicidal Disinfectants, used as directed, and/or Chlorine Bleach products, typically 5.25% So-
dium Hypochlorite in dilutions ranging between 1 part bleach to 100 parts water, and 2 parts bleach
to 100 parts water are not considered mild detergents. These products are corrosive in nature and may
cause damage to your cot if used improperly. If these types of products are used to clean Stryker patient
handling equipment, measures must be taken to insure the cots are rinsed with clean water and thoroughly
dried following cleaning. Failure to properly rinse and dry the cots will leave a corrosive residue on the surface
of the cots, possibly causing premature corrosion of critical components.
NOTE
Failure to follow the above directions when using these types of cleaners may void this product's warranty.

REMOVAL OF IODINE COMPOUNDS

1. Use a solution of 1−2 tablespoons Sodium Thiosulfate in a pint of warm water to clean the stained area.
Clean as soon as possible after staining occurs. If stains are not immediately removed, allow solution to
soak or stand on the surface. Rinse surfaces which have been exposed to the solution in clear water be-
fore returning unit to service.
WARNING
Failure to properly clean or dispose of contaminated mattress or cot components will increase the risk of expo-
sure to bloodborne pathogens and may cause injury to the patient or the operator.

Cleaning

DISINFECTANT
TYPE
Quaternary Airwick (Professional Products Division)
Quaternary Airwick (Professional Products Division)
Phenolic Huntington Laboratories
Quaternary S.C. Johnson
Quaternary Walter G. Legge
Phenolic Purex Corporation
Quaternary Purex Corporation
Phenolic Puritan Churchill Chemical Company
Quaternary Huntington Laboratories
Phenolic Vestal Laboratories
Phenolic Huntington Laboratories
Quaternary Airwick (Professional Products Division)
Quaternary Huntington Laboratories
Quaternary West Chemical Products
Quaternary Service Master
Phenolic Vestal Laboratories
1−30
MANUFACTURER
*MANUFACTURER'S
RECOMMENDED
DILUTION
2 ounces/gallon
1/2 ounce/gallon
1 ounce/gallon
2 ounces/gallon
1 ounce/gallon
1 1/4 ounce/gallon
2 ounces/gallon
1 ounce/gallon
1/2 ounce/gallon
1/2 ounce/gallon
1/2 ounce/gallon
1/2 ounce/gallon
1 ounce/gallon
2 ounces/ gallon
1 ounce/gallon
1 1/4 ounce/ gallon