Command And Safety Device Status Display Mode - Roger Technology H70/200AC Instructions Et Consignes Pour L'installateur

10.2

Command and safety device status display mode

COMMAND STATUS
AP PED
PP
CH ORO
POWER ENC1
COMMAND STATUS:
The command status indicators on the display are normally OFF.
They ILLUMINATE
illuminates).
SEGMENT COMMAND
AP open
PP step by step mode
CH close
PED partial opening
ORO clock
SAFETY DEVICE STATUS:
The safety device status indicators on the display are normally ON.
If an indicator is OFF, the relative device is in alarm state or is not connected.
The an indicator is FLASHING
SEGMENT SAFETIES
FT1 photocell FT1
FT2 photocell FT2
COS1 COS1 sensing edge
COS2 COS2 sensing edge
FCA1 gate open limit switches - LEAF1
FCA2 gate open limit switches - LEAF2
FCC1 gate close limit switches - LEAF1
FCC2 gate close limit switches - LEAF2
ENC1 Encoder MOTOR 1
ENC2 Encoder MOTOR 2
STOP STOP
SAFETY DEVICE STATUS
FT1 FT2
COS1 FCA2
COS2 FCC2
ENC2 STOP
57