Acquisition Procedure Without Encoder, Only For Opening Limit Switch Connected To The Control Unit - Roger Technology H70/200AC Instructions Et Consignes Pour L'installateur

11.3
Acquisition procedure WITHOUT encoder, ONLY for opening limit switch
connected to the control unit
WARNING: Before starting the self-acquisition procedure:
• set parameters
• set parameter
TEST
CLOSED
PROG
AP P-
x4 s 1 click
AP 2
MOTOR 1
OPEN
x2 s
CH 1 CH 2
• Press and hold PROG for 4 seconds.
• Press PROG again.
• MOTOR 1 starts opening at normal speed.
• After the delay time set with parameter
manoeuvre. is shown on the display for 2 s, and is immediately followed by
• appears on the display when MOTOR 1 reaches the open limit switch.
•
• After this 2 second interval, MOTOR 2 closes automatically. The message
• Press PROG after the required delay period (set automatically with parameter
NOTE: If the parameter is
• appears on the display for 2 seconds and is immediately followed by
• When the LEAF 2 reaches the closing mechanical stop, immediately press the PROG key.
• appears on the display.
• When the LEAF 1 reaches the closing mechanical stop, immediately press the PROG key.
If the acquisition procedure is completed successfully, the display enters the command and safety device state display
mode.
• acquisition error. Press the TEST button to clear the error, and check the safety device in alarm state.
For more information, see chapter 15 "Alarms and faults".
62
and - Deceleration space setting.
TEST
41
No
Yes
TEST
00 00
PROG
AP 1
1
MOTOR 1
OPENING
x2 s
PA PA
MOTOR 2
OPEN
PROG
CH 1
2
1
MOTOR 2
CLOSING
1 click
is shown on the display.
is shown on the display.
, (with a default time setting of 3 s), MOTOR 2 starts an opening
, MOTOR 1 closes at the same time as MOTOR 2.
C
See chapter 14 and 15
1 click
1 click
PARAM. 25
DELAY
1
TIME
... wait...
MOTOR 2
OPENING
CH 2
2
1
MOTOR 2
DESIRED
CLOSING
PROG
CLOSE
1 click
x2 s
AP 2 AP 1
2
... wait...
PROG
1
1 click
MOTOR 1
DELAY CLOSING
TIME
.
appears on the display.
). MOTOR 1 starts to close.
.
2
Yes