Commands And Accessories - Roger Technology H70/200AC Instructions Et Consignes Pour L'installateur

7

Commands and Accessories

If not installed, safety devices with NC contacts must be jumpered at the
COM terminals, or disabled by modifying the parameters
and .
N.A. (Normally Open).
N.C. (Normally Closed).
CONTACT
10(COR) 11
12(LAM) 13
14 15(ANT)
16 17 19
16 18 19
20(FCA1) 24(COM)
21(FCC1) 24(COM)
22(FCA2) 24(COM)
23(FCC2) 24(COM)
26(ORO) 25(COM)
27(AP) 31(COM)
28(CH) 31(COM)
29(PP) 31(COM)
54
DESCRIPTION
Output (potential free contact) for connecting courtesy light.
eter
Antenna connector for slot-in radio receiver board.
N.B.
Encoders are disabled by default (
WARNING! Always disconnect from electrical power before disconnecting or connecting
the encoder cable.
Encoders are disabled by default (
WARNING! Always disconnect from electrical power before disconnecting or connecting
the encoder cable.
The activation of the limit switch during door stop opening 1 (motor 1).
The activation of the limit switch during closing of sash stop 1 (motor 1).
The activation of the limit switch during sash stop opening 2 (motor 2).
Activation of the limit switch during closing of sash stop 2 (motor 2).
Clock timer contact input (N.O.).
When the clock function is active, the gate opens and remains open.
At the end of the programmed time set with the external device (clock), the gate closes.
The function of this command is determined by parameter
Open control signal input (N.O.).
Close command input (N.O.).
Step by step mode command input (N.O.).
The function of the control is determined by parameter
(potential free contact)
).
).
, , ,
.
.
.
,
-