Symbols; Product Description - Roger Technology H70/200AC Instructions Et Consignes Pour L'installateur

2

Symbols

The symbols and their meaning in the manual or on the product label are
indicated below.
Generic danger.
Important safety information. Indicates operations and situations in
which the personnel involved must pay close attention.
Dangerous voltage risk.
Indicates operations and situations in which the personnel involved
must pay close attention to dangerous voltages.
Hot surfaces risk.
Indicates danger due to hot surfaces or which anyway have high
temperatures (risk of burns).
Useful information.
Indicates useful information for the installation.
Refer to the Installation and use instructions.
Indicates the obligation to refer to the manual or original document, which
must be available for future use and must not be damaged in any way.
Protective earth connection point.
Indicates the admissible temperature range.
Alternating current (AC)
Direct current (DC)
Symbol for the product disposal according to the WEEE directive, see
chapter 22.
3

Product description

The H70/200AC control unit is intended to control gate automation systems
with 1 or 2 asynchronous single phase 230 V~ ROGER motors.
Ensure that the parameter A1 is set correctly. If this parameter is not
set correctly, the automation system may not function properly.
Use the same type of motor for both gate leaves in automation installations
for double leaf swing gates. Adjust the opening and closure speed, deceleration
gate leaves overlap correctly.
ROGER TECHNOLOGY cannot be held responsible for any damage or injury due to
improper use or any use other than the intended usage indicated in this manual.
We recommend using only ROGER TECHNOLOGY accessories and control and
For further information, refer to the MONOS4/220, R20, M20, H20, R21,
H21, H23, R23 or E30 installation manual of the automation system.
50
F2ES or F2S series photocells.