Disposal; Additional Information And Contact Details - Roger Technology H70/200AC Instructions Et Consignes Pour L'installateur

If the unit contains dirt, moisture, insects or other foreign matter, disconnect
from mains power and clean the board and the housing.
Repeat the initial installation test procedure after cleaning.
If any corrosion is found on the printed circuit board, evaluate if it is necessary
to replace the board itself.
22

Disposal

The
following suitable procedures for removing the product correctly and
safely. This product consists of numerous different materials. Some of
these materials may be recycled, while others must be disposed of
indicated by local legislation applicable for this category of product.
Do not dispose of this product as domestic refuse. Observe local legislation for
differentiated refuse collection, or hand the product over to the vendor when
purchasing an equivalent new product.
product.
Warning! Some parts of this product may contain substances that are harmful
to the environment or dangerous and which may cause damage to the
environment or health risks if disposed of incorrectly.
23

Additional information and contact details

ROGER TECHNOLOGY is the exclusive proprietor holder of all rights regarding
this publication.
are prohibited without express prior authorised from by ROGER TECHNOLOGY.
ROGER TECHNOLOGY CUSTOMER SERVICE:
To request support for any problems or for any other queries regarding the
automation system, please compile the online form "REPAIRS" in the 'Self
Service' area of our website www.rogertechnology.com/B2B.
78