Time Setting Menu; Ntp Clock; Independent Quartz Clock - Bodet Cristalys 14 NTP Instructions De Mise En Service Et D'utilisation

IV - TIME SETTING MENU

4.1 NTP clock

The receiver (NTP) clocks set themselves to the correct time
automatically.
After a reset or time change, the NTP clocks wait for three
coherent time messages before synchronising.
Remark : See the chapter "Technician Menu" page 29 to
parameter to time distribution.
Caution: if there is no NTP message reception:
on start-up, the clock displays only the two dots.
It is still possible to change the time but the clock displays only the two dots.

4.2 Independent quartz clock

The NTP receiver clocks can be configured independently; in this case you will need to set the
clock to the correct time.
Adjusting the time and date :
The [SEL] button enables you to shift between the different menus and the [+]
enables you to scroll through the setting values.
To set the clock to the correct time, proceed as follows :
1. a
When the power is on, the 2 dots flash. Press [SEL] for 2 seconds :
the hour flashes.
b
Press [+] until the required hour is shown (the display of hours takes
account of the 12 /24 hr mode, see paragraph 5 page 24).
2. a
Validate the hour by pressing [SEL] : the minutes flash.
b
Press [+] until the required minute is displayed. To synchronise your
clock to the nearest second, select the current minute +1 and as
the minute pips, validate by pressing [SEL] ;
The internal second counter is then reset to zero and starts up.
3. a
Having validated the minutes : the year flashes.
b
Press [+] until the current year is displayed.
4. a
Validate the year by pressing [SEL] : the month flashes.
b
Press [+] until the required month is displayed.
5. a
Press [SEL] to validate the month : the day flashes.
b
Press [+] until the chosen day is displayed (Scrolling of the days
takes account of the month and year selected (leap years)).
6. a
To conclude time setting, press the [SEL] button.
6
Maintaining pressure on the [+] button for longer enables you to increase the values rapidly (minutes, hours,
days, etc).
22
SELECT
6
button