Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
VIII - Configuration and setting the time
These two keys are located on the bottom of the clock (see below).
In all the menus, you use the "+" key to choose your settings and the "Select" key to confirm
them.
8.1 Configuration menu
To access this menu, press the "Select" key for 3 seconds.
The clock displays the previously selected operating mode :
Operating mode
Independent or integrated radio synchronization
Slave Minute
(on INDEP. QUARTZ/MIN. - 1/2 MIN. Model)
Slave 1/2 Minute
(on INDEP. QUARTZ/MIN. - 1/2 MIN. Model)
Slave Afnor / Irig B or DHF
(on INDEP. QUARTZ/MIN. AFNOR-IRIG B or
DHF model).
Note : If an antenna has been connected, the "Ind" mode is selected automatically. Pressing "+"
will have no effect and it is not possible to select "Min", "1/2 M" or "Afn".
8.2 Time setting
In the configuration menu, when the selected mode, e.g. "Ind" is displayed, press the "Select"
key to confirm.
The clock then moves on to the set time mode.
28
The hours flash
Set the hours and confirm.
The minutes flash
Set the minutes and confirm.
NB. the seconds are reset to zero each time the minutes are reset.
Display
Publicité
Table des Matières
