Time Setting Menu; Ntp Clock; Independent Quartz Clock - Bodet Cristalys Opalys 7 NTP Instructions De Mise En Service Et D'utilisation

IV - TIME SETTING MENU IV - TIME SETTING MENU

4.1 NTP clock

The receiver (NTP) clocks set themselves to the correct time automatically.
After a reset or time change, the NTP clocks wait for three coherent time messages before
synchronising.
Remark : See the chapter "Technician Menu" page 28 to parameter to time distribution.
Caution: if there is no NTP message reception:
- on start-up, the clock displays only the two dots.
- It is still possible to change the time but the clock displays only the two dots.

4.2 Independent quartz clock

4.2 Independent quartz clock
The NTP receiver clocks can be confi gured
independently; in this case you will need to set the clock
to the correct time.
Adjusting the time and date :
The [SEL] button enables you to shift between the
different menus and the [+]
through the setting values.
To set the clock to the correct time, proceed as follows :
1. a On installing of the power supply, the 2 dots fl ash. Press [SEL] for 2
seconds : the hour fl ashes.
b Press [+] until the required hour is shown (the display of hours takes account of the 12 /24 hr
mode, see paragraph 5 page 23).
2. a Validate the hour by pressing [SEL] : the minutes fl ash.
b Press [+] until the required minute is displayed. To synchronise your
clock to the nearest second, select the current minute +1 and as the
minute pips, validate by pressing [SEL] ;
The internal second counter is then reset to zero and starts up.
3. a Having validated the minutes : the year fl ashes.
b Press [+] until the current year is displayed.
4. a Validate the year by pressing [SEL] : the month fl ashes.
1 Maintaining pressure on the [+] button for longer enables you to
increase the values rapidly (minutes, hours, days, etc).
button enables you to scroll
1
Reset
Sel.
21