Time Setting Menu; Quartz Clock - Bodet Cristalys Ellipse Instructions De Mise En Service Et D'utilisation

IV - TIME SETTING MENU

4.1 Quartz clock

Adjusting the time and date :
The [SEL] button enables you to shift between the different
menus and the [+]
setting values.
Each time [SEL] is pressed, the option that is flashing
is validated.
The language depends on the configuration menu, at
the 1st setting up the language is French. (see the
chart "Rule on the used language page 46)
To set the clock to the correct time, proceed as follows :
1. a On installing the batteries or on the initial powering up, the time is initialised
at 00h00 01/01/2000. Press [SEL] for 2 seconds : the hour flashes.
b Press [+] until the required hour is shown (the display of hours takes
account of the 12 /24 hr mode, see paragraph 5 page 33).
2. a Validate the hour by pressing [SEL] : the minutes flash.
b Press [+] until the required minute is displayed. To synchronise your
clock to the nearest second, select the current minute +1 and as the
minute pips, validate by pressing [SEL];
The internal second counter is then reset to zero and starts up.
3. a Having validated the minutes : the year flashes.
b Press [+] until the current year is displayed.
4. a Validate the year by pressing [SEL] : the month flashes.
b Press [+] until the required month is displayed.
5. a Press [SEL] to validate the month : the day flashes.
b Press [+] until the chosen day is displayed (Scrolling of the days takes
account of the month and year selected (leap years)).
6.a Press on [Sel] to validate the day of the month: So the clock displays :
1 Maintaining pressure on the [+] button for longer enables you to
increase the values rapidly (minutes, hours, days, etc).
30
button enables you to scroll through the
1
Reset
Sel.
C