Time Setting Menu; Ntp Clock; Independent Quartz Clock - Bodet Cristalys Opalys 7 NTP Instructions De Mise En Service Et D'utilisation

IV - TIME SETTING MENU

4.1 NTP clock

The receiver (NTP) clocks set themselves to the correct time automatically.
After a reset or time change, the NTP clocks wait for three coherent time messages before
synchronising.
Remark : See the chapter "Technician Menu" page 29 to parameter to time distribution.
Caution: if there is no NTP message reception:
on start-up, the clock displays only the two dots.
It is still possible to change the time but the clock displays only the two dots.

4.2 Independent quartz clock

The NTP receiver clocks can be configured
independently; in this case you will need to set the
clock to the correct time.
Adjusting the time and date :
The [SEL] button enables you to shift between the
different menus and the [+]
scroll through the setting values.
To set the clock to the correct time, proceed as follows :
1. a
On installing of the power supply, the 2 dots flash. Press [SEL] for 2 seconds : the hour
flashes.
b
Press [+] until the required hour is shown (the display of hours takes
account of the 12 /24 hr mode, see paragraph 5 page 24).
2. a
Validate the hour by pressing [SEL] : the minutes flash.
b
Press [+] until the required minute is displayed. To synchronise your
clock to the nearest second, select the current minute +1 and as
the minute pips, validate by pressing [SEL] ;
The internal second counter is then reset to zero and starts up.
3. a
Having validated the minutes : the year flashes.
6 Maintaining pressure on the [+] button for longer enables you to increase the values rapidly
(minutes, hours, days, etc).
22
6
button enables you to
Reset
Sel.