Installation; Time Setting Menu; Independent Quartz Clock - Bodet Cristalys 7 Instructions De Mise En Service Et D'utilisation

3.4 Installation

Setting of the table bracket (if supplied)
(in the 2 notches of the wall bracket).
■ Fit the wall bracket using the plugs and screws supplied.
■ Clip the clock in place on the bracket and secure with the anti-theft locking screw provided (see
diag.2).
■ Remove the protective sheet from the front panel and use the anti-static cloth to clean the clock.
Mounting on vertical bracket or ceiling bracket :
■ Cristalys clocks can be installed on various types of brackets (ref. 938901, 938907 and
938908). See the installation manual delivered with the bracket.
Remark : the clock could be installed on a table fixing (in option), see figure 2.
IV - TIME SETTING MENU

4.1 Independent quartz clock

Adjusting the time and date
The [SEL] button enables you to shift between the different menus and the
[+] button enables you to scroll through the setting values.
1
Caution : it is necessary to set up the clock in independent synchronisation mode in order to get
a proper operation (see page 32).
To set the clock to the correct time, proceed as follows :
1. a On installing the batteries, the 2 dots flash. Press [SEL] for 2 seconds :
the hour flashes.
b Press [+] until the required hour is shown (the display of hours takes
account of the 12 /24 hr mode, see paragraph 5 page 26).
1 Maintaining pressure on the [+] button for longer enables you to
increase the values rapidly (minutes, hours, days, etc).
24
143
100
Fig.: 2
Reset
Sel.
Anti-theft locking
screw
SELECT