Installation; Time Setting Menu; Independent Quartz Clock - Bodet Cristalys 14 Instructions De Mise En Service Et D'utilisation

distribution network.
Connect the time coded line to terminals 1 and 2 on the terminal strip.
Time distribution type has to be configured in the technician menu (see page 33).
Time synchronisation: Minute //,
½ minute // from 12 to 48V or
IRIG-B/AFNOR impuls
Remark : There is no polarity, but if there is several clocks, they have to be connect in the same
order.

3.4 Installation

■ Fit the wall bracket using the plugs and screws supplied.
■ Clip the clock in place on the bracket and secure with the anti-theft locking screw provided (see
diag.2).
■ Remove the protective sheet from the front panel and use the anti-static cloth to clean the clock.
Mounting on vertical bracket or ceiling bracket :
■ Cristalys clocks can be installed on various types of brackets (ref. 938901, 938907 and
938908). See the installation manual delivered with the bracket.
Remark : the clock could be installed on a table fixing (in option), see figure 2.
IV - TIME SETTING MENU

4.1 Independent quartz clock

Adjusting the time and date
The [SEL] button enables you to shift between the different menus and the
[+] button enables you to scroll through the setting values.
1
Caution : it is necessary to set up the clock in independent synchronisation mode in order to get
a proper operation (see page 33).
To set the clock to the correct time, proceed as follows :
1. a On installing the batteries, the 2 dots flash. Press [SEL] for 2 seconds :
the hour flashes.
b Press [+] until the required hour is shown (the display of hours takes
account of the 12 /24 hr mode, see paragraph 5 page 26).
2. a Validate the hour by pressing [SEL] : the minutes flash.
1 Maintaining pressure on the [+] button for longer enables you to
increase the values rapidly (minutes, hours, days, etc).
24
All manuals and user guides at all-guides.com
Reset
SELECT
Fixing points
∞
C
SELECT