Enerpac Pro TSP300 Serie Manuel D'instructions page 3

A
6. Install the four new socket head capscrews (D). Tighten
them to the torque applicable to your wrench or drive unit
model:
a. S1500X, S3000X, W2000X and W4000X Series Models:
3.7 Ft.lbs [5.1 Nm].
b. S6000X, S11000X, S25000X, W8000X and W15000X
Series Models: 7.5 Ft.lbs [10.2 Nm].
c. W22000X and W35000X Series Models:
7.5 Ft.lbs [10.2 Nm].
B
C
G
D
E
F
D
H
E
B1
8
B2
N
G
8
B
Apply silicone grease
✤
to all O-rings.
Figure 1, Exploded View - TSP300 Pro Series Swivel
A
B
C
D
F
H
B3
N
8
✽
Apply Loctite 243
Thread Sealant.
(inside bolt holes)
G
Figure 2, O-ring Installation, Swivel Post
B2
N
Figure 3, O-ring Installation - Swivel Manifold Block
7. Install the new swivel post O-ring (E) from the kit. Coat the
O-ring with silicone grease before installing. See Figure 2 for
location.
8. Install the TSP swivel onto the swivel post. Test for proper
operation. Refer to steps 6 through 9 of Section 4.0 for
instructions.
6.0 HYDRAULIC COUPLING REPLACEMENT
Replace the hydraulic couplings as described in the following
steps: Refer to Figures 1 and 4.
1. Remove the circlip retainer ring (A) from the top of the swivel
B2
N
post (F).
2. Using a pair of screwdrivers, gently pry the swivel assembly
(B) off of the swivel post (F).
B4
NOTICE Use a vise with soft jaws to hold the swivel when
removing and installing hydraulic fittings in the following steps.
To prevent possible damage to wrench, never attempt to tighten
the hydraulic fittings while the swivel is installed on the wrench.
3. Place the swivel assembly in a vise with soft jaws, and
remove the old male coupling (B1), adapter (B2) and female
coupling (B3).
4. In preparation for reinstallation, remove any deposits of
dried thread sealant remaining on the threads of the swivel
assembly (B).
B7
NOTICE Inspect all components before reassembly. Always
B6
replace any worn or damaged parts with new ones.
3
C
E
G
B1
C
B3
N
B2
N
B
B1
A
B8
B6
B7
E
B1
B
B9
8
B