Important Warning - Chicco Seat 4 Fix Mode D'emploi

proved by the ECE R44/04 Standards for use in
vehicles equipped with ISOFIX safety anchor-
age systems.
In this configuration the child car seat is clas-
sified for UNIVERSAL use. The child mass
group and ISOFIX size class for which the child
restraint may be used in this configuration are:
GROUP 1, class B1.
In case of doubts, contact the manufacturer
of the restraint device or your dealer.
WARNING! When using ISOFIX, the attach-
ment of the lower anchorage systems is not
sufficient. It is also essential to attach the "Top
Tether" to the anchorage point made available
by the vehicle manufacturer.

IMPORTANT WARNING

FITTING THE CHILD CAR SEAT AND SEAT-
ING CHILDREN IN GROUP 2/3 USING THE
CAR'S THREE-POINT-BELT (15-36 KG)
This is a 'Universal' child retention device, ho-
mologated according to ECE Regulation no.
44, amendments of series 04. suitable for gen-
eral use in vehicles and compatible with most
but not all vehicles' seats.
2. A correct fit is likely if the vehicle manufac-
turer has declared that the vehicle is capable
of fitting a "Universal" child restraint for this age
group.
3. This child restraint device has been classified
as "Universal" under more stringent conditions
than those that were applied to earlier designs
that do not display this notice.
4. Suitable exclusively to be used in vehi-
cles equipped with 3-point safety harnesses,
whether static or with winder, approved ac-
cording to UN/ECE Regulation no. 16 or other
equivalent standards.
5. In case of doubts, contact the manufacturer
of the restraint device or your dealer.
IMPORTANT WARNING
2.5 INSTALLING THE CAR SEAT IN THE CAR
AND PLACING THE CHILD IN THE GROUP
2/3 CONFIGURATION WITH ISOFIX CON-
NECTORS, TOP TETHER AND THE CAR'S
THREE-POINT SEAT BELT (15-36 KG)
This child restraint system is classified as
SEMI-UNIVERSAL according to Regulation No.
ECER44/04 and is only compatible with the ve-
hicles indicated in the "List of vehicles";
Suitable exclusively to be used in vehicles
equipped with 3-point safety harnesses,
whether static or with winder, approved ac-
cording to UN/ECE Regulation no. 16 or other
equivalent standards.
In case of doubts, contact the manufacturer
of the restraint device or your dealer.
1.4 RESTRICTIONS AND REQUIREMENTS
REGARDING THE USE OF THE PRODUCT
AND VEHICLE SEAT
WARNING! Strictly comply with the following
restrictions and requirements for use concern-
ing the product and vehicle seat: safety will
not be guaranteed otherwise.
• This Car Seat is type-approved for use with
children who weigh from 0 to 36 kg (from birth
until roughly 12 years of age).
• The vehicle's seat must be equipped with
3-point safety harness, whether static or with
a retractor, approved according to UN/ECE
Regulation no. 16 or other equivalent stand-
ards (Fig. 1).
WARNING! Never fit the child car seat to a ve-
hicle seat that is only equipped with a 2-point
safety belt (Fig. 2).
In the Group 0+ configuration (0-13 kg) the
Car Seat may only be fixed to the front seat if
the airbag has been deactivated.
Never use this child car seat on rear-facing or
side-facing car seats (Fig. 3).
• This product is expressly intended to be used
only as a child car seat; it is not meant for use
indoors.
• It may happen that the vehicle seat belt
buckle is too long and exceeds the expected
height above the bottom of the car seat (Fig.
4A-4B). In this case the seat must not be fixed
on that seat but must be installed on another
seat on which there is no problem. For more
information, contact your car manufacturer.
WARNING! Group 2/3. When using in vehicles
29