Fitting Instructions - R&G CP0402BL Instructions De Montage

Picture 17
Picture 19

FITTING INSTRUCTIONS

Left side (as you sit on the bike)

To fit the R&G crash protectors the side fairing cowls need to be removed from both sides of the bike.

Remove the bolt that secures the seat infill panel in place, as shown in picture 1 and remove from the bike
by pulling the panel out of the rubber mounts at the front, then at the rear, as shown in picture 2.

Remove the two bolts that are arrowed in picture 3 and remove the plastic panel by pulling the panel out of
the rubber mount at the top, then at the front of the panel, before twisting upwards to remove from the
plastic clips at the front of the panel, as shown in pictures 4 & 5.

Remove the bolt that is now accessible and secures the side fairing in place, as arrowed in picture 6.

On the inside of the fairing panel next to the radiator, there are three push rivets that need to be removed
from the radiator cowl, as arrowed in picture 7.

Remove the two bolts that secure the bellypan in place on the lower side of the bike, as shown in picture 8.

Remove the two push rivet connectors that attach both sides of the bellypan at the front of the bike, as
arrowed in picture 9.

The bellypan can now be separated from the right side and the side fairing removed from the bike. There is
one rubber mount to release along with the connector for the regulator/rectifier that needs to be
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
R&G Racing
www.rg-racing.com Email:
CP0402
Picture 18
Picture 20
info@rg-racing.com