Battery Pack And Charging Procedure - Babboe Mountain Manuel D'utilisation

F. BATTERY PACK AND CHARGING PROCEDURE
The battery pack equipped for the Yamaha e-Bike Systems is a
lithium-ion battery. The lithium-ion battery is lightweight and
offers superior capacity. However, it does have the following
characteristics.
• Its performance decreases in extremely hot or cold
environments.
• It naturally loses its charge.
The battery pack for the Yamaha e-Bike Systems also has an embedded computer which notifies you of estimated
residual battery capacity and suspected faults via the battery capacity indicator lamp.
By pressing the battery capacity indicator button, you can display the residual battery capacity for approximately
5 seconds.
See "Checking the residual battery capacity" for the estimate of the residual battery capacity. See
"Troubleshooting" for information on fault flashing.
Do not use any other charger or charging method to recharge the special batteries. Using any other charger could
result in fire,
explosion, or damage the batteries.
Important safety instructions — save these instructions to reduce the risk of fire or electric shock, carefully
follow these instructions. This manual contains important safety and operating instructions for battery charger
Type PASC5. Before using battery charger, read all instructions and cautionary markings on battery charger,
battery and product using battery. Only use it to charge PASB2, PASB4, and PASB5 type batteries for Yamaha
e-Bike Systems. Other types of batteries may burst causing injury to persons and damage.
NOTICE
Do not apply grease on the terminal of the battery.
Appropriate charging environments
For safe and efficient charging, use the battery charger in a location that is:
• Flat and stable (when on the bicycle)
• Free of rain or moisture
• Out of direct sunlight
• Well-ventilated and dry
• Not accessible to children or pets
• Temperature between 15–25 °C
56
mate of the residual battery capacity. See "Troubleshoot-
ing" for information on fault flashing.
Charging plug
Charging connector Power plug Do not use any other charger or charging method to
recharge the special batteries. Using any other charg-
Battery capacity
Battery
er could result in fire, explosion, or damage the bat-
indicator lamp
capacity
teries.
indicator
IMPORTANT SAFETY INSTRUCTIONS — SAVE THESE
INSTRUCTIONS
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, CAREFULLY FOLLOW THESE INSTRUC-
Battery capacity
Charging connector indicator button TIONS
This manual contains important safety and operating
instructions for battery charger Type PASC5.
Before using battery charger, read all instructions and
cautionary markings on battery charger, battery and
product using battery.
Only use it to charge PASB2, PASB4, and PASB5 type
batteries for Yamaha e-Bike Systems. Other types of
batteries may burst causing injury to persons and
damage.
NOTICE
Do not apply grease on the terminal of the battery.
X0S7_EPAC欧州向け英語_MY19.indd 32
WARNING
Inappropriate charging environments and solutions
The hot and cold environments described below can cause charging to enter standby or suspension without fully
charging the battery.
WARNING
• Summertime charging standby/suspension
If charging in a location receiving direct summer sunlight or immediately after riding, the battery charger
might enter charging standby (all four battery capacity indicator lamps flash slowly). See "Reading the
charging status for battery pack". This is to automatically stop charging in order to protect the battery from
exceeding the specified temperature while charging. You can avoid charging suspension by starting to charge
with the battery cold or at a room temperature of 15– 25 °C. If charging suspension occurs, move the battery
charger to a cool location to reduce the charging standby time.
• Wintertime charging standby/suspension
Charging standby will occur if the temperature is less than 0 °C. If charging is started and the temperature drops
below this level due to late-night cooling or other factors, charging is suspended and standby mode is entered to
protect the battery. In such cases, restart charging at an indoor location with a temperature of 15–25 °C.
• Noise on televisions/radios/computers
Charging next to televisions, radios, or similar appliances might cause static, flickering images, and other
interference. If this occurs, recharge in a location further away from the television or radio (such as in another room).
If a charging fault occurs during charging, remove the power plug of the battery charger from the socket and wait
for the battery pack/battery charger to cool.
32
NOTICE
• Do not connect the charging plug of the battery charger with the charging connector of the battery
in a wet state.
• Be sure to connect the charging plug only after the charging connector on the battery pack is completely dry.
Otherwise the battery charger and battery pack may malfunction.
• Do not apply excessive force to the charging plug or pull on the cord with the charging plug connected
to the battery. Otherwise, the plug or connector may be damaged.
• Do not pedal while the charging plug is connected.
Never handle the power plug, charging plug or touch the charger contacts with wet hands. This could result
in electric shock.
2018/04/04 9:29:50
57