Starting And Stopping The Engine; Before Starting The Engine; How To Start The Engine; Ignition Switch - GOLDONI TWIST 5 Notice D'utilisation Et D'entretien

GOLDONI S.p.A.
STARTING AND STOPPING THE
ENGINE

Before starting the engine

To start the engine, it is advisable to shift the
gears, the PTO and the reverse shuttle to the
neutral position and leave the Gear Stop
in the raised position so as to disengage the
clutch. Move the red engine stop switch
ON position.

How to start the engine

See engine's operation
manual.
IMPORTANT
Carefully follow the instructions to start
the engine pulling strap
EN Inglese
lever
to the
and maintenance

Ignition switch

Insert the key and turn it as described
below:
Position 0
No circuit powered.
Position 1
Insert the key and turn it clockwise to
the first position (the electrical circuit
will be powered).
Position 2
Engine starts.
Each starting attempt should last for just a few
seconds.
Do not make consecutive attempts to start the
engine without having waited at least 20 sec.
between one attempt and the next, otherwise the
battery will quickly run down and the starter motor
could be damaged.
WARNING
Do not keep operating the starter motor
when the engine has already started.
Damage to the starter motor due to
failure
instructions will not be covered by the
warranty.
After the engine has started:
Release the key. It will automatically return
to the operating position
87
to comply with
OPERATING INSTRUCTIONS
TWIST
these