Fire Prevention; Tire Safety Measures - GOLDONI TWIST 5 Notice D'utilisation Et D'entretien

GOLDONI S.p.A.

Fire prevention

Remove grass and debris from the
engine compartment and silencer area
before and after using the machine.
Always shut off the fuel valve, if
installed, when the machine is stored
or transported.
Do not park the machine near an open
flame or source of ignition, such as a
water heater or a boiler.
Frequently check the fuel lines, the
tank, plugs and fittings for cracks or
leaks. Replace them if necessary
Never store the machine with fuel in the
tank inside a building where fumes
could reach an open flame or spark.
Allow the engine to cool before storing
the machine in a closed place.
EN Inglese

Tire safety measures

Explosive separation of a part of tire and
rim can cause serious injury or death:
Never attempt to mount a tire without
the proper equipment and experience
to perform the job.
Always
pressure. Do not inflate the tires above
the recommended pressure. Never
weld or heat a wheel and tire assembly.
Heat can cause an increase in air
pressure resulting in a tire explosion.
Welding can structurally weaken or
deform the wheel.
When inflating tires, use a clip-on
chuck and
enough to allow you to stand on one
side and NOT in front of or over the tire
assembly.
Check tires for low pressure, cuts,
blisters, damaged rims or missing lug
bolts and nuts.
80
maintain the correct
extension hose
TWIST
tire
long
SAFETY