Display Set - Power One AURORA PVI-3.8-I-OUTD Manuel D'utilisation Et D'installation

Installation and operating manual
(PVI-3.8/4.6-I-OUTD Rev.: 1.5)
GENERAL QUESTIONS REGARDING READING THE DISPLAY.
The selected entry will be highlighted by an arrow on the left-hand side of the display.
Once the chosen entry is selected, press ENTER to enter its submenu.
5.5.6.1 Address
Using this function, you can set the addresses for the communication of individual
inverters connected to the system on the RS485 line. The numbers assigned can go
from 2 to 63. Use the UP and DOWN keys to scroll through the numbers.
The 'AUTO' selection is not usable at the moment
5.5.6.2

Display Set

This function allows you to set the display characteristics:
1) Light: display light setting:
- With the MODE key, it is possible to control the display backlighting.
After selecting the Mode entry with the arrow and pressing ENTER, you will access
the following submenu. The next screen is:
ON : Light always on
OFF : Light always off
New Address
63
Light
Contrast
Buzzer
Mode
Intensity
ON
OFF
Auto
Page 67 of 95
AUTO
2
3
.....
.....
62
64
AUTO