Power One AURORA PVI-3.8-I-OUTD Manuel D'utilisation Et D'installation page 57

Installation and operating manual
(PVI-3.8/4.6-I-OUTD Rev.: 1.5)
If the system is grounded (one of the two poles is connected to the ground) the first
screens will be as follows
GND ISO SELFTEST
RUN ... Vgnd 130V
If instead, the system is ungrounded (neither of the two poles is connected to the
ground), the first screen will be as follows:
After the first control, the following screens will alternate between them
V grid 223.8 V
OK
The grid voltage and frequency values will be displayed along with information
regarding whether they are inside or outside the range, until the connection is made
When connected, a beep will sound from the buzzer and from this point, the screens
will show the measurements, as described in paragraph 5.5.3.
GND ISO SELFTEST
OK
Control grid:
30 sec
Fgrid 50.17 Hz
OK
Page 56 of 95
Vgnd 130V
Connection
........................